Veteran Garage Door Repair | Keller TX | 817-769-8488

Garage Door Opener Repair

You may discover that your garage door opener has been offering you troubles, so you require to repair it. You can fix it by replacing a circuit board, a photo-eye sensor, the primary drive equipment, or the set-limit buttons. You can also inspect if the safety and security sensing units are working correctly.

Replacing a circuit board

Changing a circuit card for your garage door opener requires a couple of steps as well as devices. Initially, you need to shut off the circuit breaker as well as disconnect any kind of wires. Next off, open the motherboard cover. This will certainly aid you to diagnose the trouble as well as determine if you require a new board. Next off, eliminate the old board as well as its cable connectors.

You can then continue to change the motherboard. The substitute procedure is very easy and also takes around 10 mins. A new circuit card will set you back regarding $80. To protect your new motherboard from power surges, you can acquire a surge guard.

Replacing a photo-eye sensing unit

Changing a photo-eye sensing unit can be a fairly straightforward job. First, get rid of the sensing unit from the door and also ensure it is positioned properly. If the sensor is angled at all, it may not be obtaining the right signal, which could be triggering the strobe lights. If you discover that the photo-eyes run out placement, you might require to have actually a service technician come as well as take care of the problem.

The photo-eye sensor includes 2 pieces that place on the outside of the door tracks and toward the flooring. The photo eyes will certainly have a little LED light as well as ought to be solid in shade. If the light is blinking, its most likely the photo-eye is faulty and will require to be replaced.

Changing a major drive gear

To change a garage door opener major drive equipment, start by eliminating the cap from the chain wheel. Next, eliminate the two screws holding the drive gear to the gear assembly. Now, you can unfasten the 3 stress pins. Press them from both sides and afterwards eliminate them. Then, detach the three cables from the garage door opener electric motor. These wires should be white, red, as well as blue.

As soon as you have actually gotten rid of the old gear, set up a brand-new one. Be sure to oil it well. Place the new gear right into the shaft, making sure to align the mounting openings. See to it the gear as well as sprocket setting up are positioned correctly to ensure smooth operation. Next off, make use of a hammer and a nail to drive a pin right into the brand-new gear.

Readjusting the set-limit switches

The first point you should do if your garage door is not working correctly is to check the set-limit buttons. You might require to readjust them so that the door shuts earlier or stops before it reaches the floor. You can examine this by taking a look at your garage doors manual or online.

To change the set-limit buttons, youll require a screwdriver or outlet. Readjust the handle clockwise or counterclockwise up until the door goes up and stops, or decreases its distance. To look for correct traveling range, measure the space from the bottom of the garage door to the ground.

Veteran Garage Door Repair – Keller

204 S Key St Ste 105, Keller, TX 76248, USA

817-769-8488

https://veterangaragedoor.com/veteran-garage-door-repair-of-keller-tx/


Garage Door Repair


Garage Door Installation


Garage Door Company


Garage Door Service


Garage Door Opener Repair

Veteran Garage Door Repair

204 S Main St Ste 105
Keller,TX
76248
817-769-8488

Garage Door Repair Garage Door Repair near me